GIS-R80
This guide will walk you through the initial installation and connection to your Guest Internet unit so that you can connect to the admin interface.
Your GIS-R80 unit:
The necessary cables to setup your unit:
Connection Steps
- Connect an Ethernet cable on the WAN port to your router
- Power on the GIS-R80 by connecting the power supply provided
- Wait 30 seconds for the GIS unit to complete the boot process
- Connect an Ethernet cable on the LAN port and connect the other end to your computer/AP
- Open your browser at https://aplogin.com/admin
- The next step to configure your GIS unit is to follow the wizard available here
If you run into any issue with the installation of your unit please contact us.
If you need to Reset to Factory Defaults please click here
